The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
THE JQRacing Gearbox Screw set includes 4pcs of these long M4 screws, that secure the two halves of the gearbox, along with the front and rear arm holders together.
THE JQRacing Wheel Bearing Spacer Set includes 4pcs, enough for one car. These crush spacers are added between the wheel bearings to prevent the bearings from binding when the hex pin grubscrew is tightened.
THE JQRacing Centre Bevel Gear Outdrive Set includes two outdrives, with the needed M5x4 grubscrews. These outdrive cups are installed on the front or rear bevel gear, and are used to transfer the rotational force from the center drive shafts to the...
THE JQRacing Upper Link (Camber Link) Turnbuckle Set includes four Camber Link Turnbuckles that are used in either the front or rear. These are used to adjust the camber and roll center on the front and rear of the chassis.
A good idea...
THE JQRacing 6mm Steering Servo Link Ball Set includes two pivot balls that are used in the steering servo link rod ends. One ball is threaded with a 5.5 hex shape, and the other is just a simple ball.
THE JQRacing 7mm Outer Steering Ball Set includes four pivot balls that are used in the outer steering links on the original YE, THEeCar and THERTR, and both inner and outer links on all new cars.
THE JQRacing 7mm Upper Link Ball Set includes four steel balls. These are the outer camber link pivot balls that are installed in the front or rear camber link rod ends and attached to the hubs.
THE JQRacing 7mm Threaded Ball with Nut Set includes four steel balls. These are the inner camber link pivot balls that are installed in the front or rear camber link rod ends and attached to the shock towers.
THE JQRacing Servo Saver Post Set includes both posts needed for a car. These posts are installed on the chassis, and hold the servo saver components in place.
THE JQRacing Rear Differential Bearing Insert, just in case you don’t want to buy the complete rear gearbox but want to replace the bearing insert.
THE JQRacing Swaybar Holder Set includes two swaybar holders, one for the front, and one for the rear.
THE JQRacing Chassis Braces includes one front, and one rear brace. The rear brace is the original design, and as such is only compatible with THEeCar, the original THECar, and the Original YE. Both have been discontinued from the factory,...